Bathroom Sink Repair Pleasant Grove AL

When it comes to bathroom sink repair, there are a couple of common problems individuals have: leaky drains, chips in the porcelain and cracks in the ceramic of the sink. Each is easily solvable with the right know-how.

Leaky Bathroom Drains

Leaky drains prevail in fundamental sink repair work, yet easily dealt with. The first thing you'll have to do is find where the leakage is coming from. To do this, let water range from the faucet into the sink. Ensure you have a bucket positioned to catch water. Shine a flashlight onto the pipelines, and wrap a paper towel around each one to identify the location of the leakage. Next, tighten the couplings in the drainpipe with the leakage. If this does not fix the problem, try cleaning the pipe threads and changing the gasket. To do this, you'll have to separate the sink basket from the basin, using a wrench to loosen up the nuts. Keep the basin in place with a screwdriver or a pair of pliers in the crosspiece. Scrub off all of the old putty, then insert the brand-new gasket, followed by the sink basket. Once this is done, it's just a matter of tightening up the washer nut, using sealant, and evaluating the drains once again.

Porcelain sink repair deals with chips more than fractures, just as ceramic sink repair includes fractures more than chips. However, you can take the very same actions to handle both. Initially, you have to clean the sink to the best of your ability, so as not to get dirt permanently in the sealant.

Sink Replacement

Later on, utilize sandpaper to sand the cracked location. Be careful not to scratch the smooth surrounding surface with the sandpaper. Once the chip or gouge has been sanded, apply a silicone filler or repair compound to the damaged location. Allow it to dry as instructed by the producer, then sand down the repaired area so that the filled area is level with the remainder of the sink. Finally, discover a porcelain touch-up paint that best matches your sink's color and apply to the fixed location.
Your sink stopper may also require repair or replacement. If you have a sink stopper, there will be a horizontal pivot rod connected to a vertical clevis, which secures the stopper to the sink. Remove both the clevis and the pivot rod, soaking them in vinegar or another cleansing option. Meanwhile, remove the stopper from the drain and check it for damage. Pay special attention to the rubber seal. If you have to change the seal or stopper, it's a basic matter of following the producer's instructions. Otherwise, soak the stopper in the cleaning solution, reassemble the pivot rod and clevis, and test to see if it's working.